MSB-430H

Support for the ScatterWeb MSB-430H board. More...

Detailed Description

Support for the ScatterWeb MSB-430H board.

Hardware

ScatterWeb MSB-430H

MCU

MCU TI MSP430F1612
Family MSP430
Vendor Texas Instruments
Package 64 QFN
RAM 5Kb
Flash 55Kb
Frequency 8MHz
FPU no
Timers 2 (2x 16bit)
ADCs 1x 8 channel 12-bit
UARTs 2
SPIs 2
I2Cs 1
Vcc 2.0V - 3.6V
Datasheet / Reference Manual Datasheet
User Guide User Guide

Radio

RF Chip Texas Instruments® CC1100
Frequency Band 300-348MHz, 400-464 MHz, and 800-928 MHz
Standard compliance DASH7 compliant
Receive Sensitivity -94dBm typ
Transfer Rate 500kBaud
RF Power -30dBm ~ 10dBm
Current Draw RX: 14.4mA TX: 16.9mA Sleep mode: 400nA
RF Power Supply 2.1V ~ 3.6V
Antenna Dipole Antenna / PCB Antenna
Datasheet Datasheet

Flashing RIOT

Flashing RIOT on the MSB-430H is quite straight forward, just connect your board using a JTAG adapter (either the original one from TI or an Olimex version) to your host computer and type:

make flash

This should take care of everything!

Using the shell

The shell is using the UART interface of the MSB-430H at 115200 baud. You need a 3.3V TTL serial cable. For USB connections you could use a FTDI connector

More information

FU Berlin info page on the MSB-430H

Files

file  boards/msb-430h/include/board.h
 Basic definitions for the MSB-430H board.
 
file  boards/msb-430h/include/periph_conf.h
 MSB-430h peripheral configuration.